Table of Contents
Advertisement
Installing POTS Splitter Modules in the POTS Splitter Chassis
Procedure
If POTS splitter modules are not installed in the chassis:
DSL
Connector
Figure 1. 5910 POTS Splitter – Front
Figure 2. 5910 POTS Splitter – Rear
4
1. From the front of the chassis, slide a module into a free bay while holding the
plastic locking tab in the downward, unlocked position.
2. Ensure that the bottom of the locking tab enters its slot in the base of the
chassis as you slide in the module.
3. Press the locking tab into its upright, locked position.
4. Repeat for all the modules you have to install.
Locking Tab
Line
PSTN
May 2005
Line
5910-A2-GZ40-00
Advertisement
Table of Contents
