Installation Of The Driver; Installing The Driver For Windows95 Osr2 (4.00.950B) - Yamaha SW1000XG Owner's Manual

Installation of the
To use SW1000XG sound card, the appropriate driver (SW1000XG Windows95 Driver) should be
properly installed in your computer. The driver can be installed from the supplied CD-ROM by
following the steps described below.
n
Before installing the driver, make sure that the sound card itself is installed in the computer. (
n
Open the "General" page of the System Properties in your Windows' Control Panel. If your Windows95 version is
shown as "4.00.950B", refer to "Installing the driver for Windows95 OSR2 (4.00.950B)". If your Windows95 version
is shown as "4.00.950" or "4.00.950A", refer to "Installing the driver for Windows95 (4.00.950 or 4.00.950A)".

Installing the driver for Windows95 OSR2 (4.00.950B)

1.
Turn on the power of your computer. If you turn on it for the first time after installing the
sound card in your computer, the Updated Device Driver Wizard will appear automatically.
2.
Insert the supplied CD-ROM in the CD-ROM drive and click [Next]. The message saying
"Windows was unable to locate a driver for this device" will be displayed.
Driver
13
P. 10)