Installing The Plug-In Board; Installing The Digital Mixing Card - Yamaha SW1000XG Owner's Manual

Installing the Plug-In Board

Refer to the illustration below to install an optional plug-in board (PLG100 series).
Making sure that the plug-in board is facing in the correct direction, carefully press the cable
from the plug-in board into the plug-in board connector on the sound card.
Connector to SW1000XG
Connector to plug-in board
Yellow line
Hooks To plug-in board
Spacer
To SW1000XG
n
This should be done before the sound card is installed in the computer.
n
For information about each plug-in board, see page 24 and the owner's manual that comes with each board.

Installing the Digital Mixing Card

Refer to the illustration below to install an optional digital mixing card (DS2416).
Making sure that the flat cable from the digital mixing card (DS2416) is facing in the correct
direction, carefully press the cable into the digital mixing card connector on the sound card.
Green line
Connector to DS2416
Connector to SW1000XG
n
This should be done before the sound card is installed in the computer.
n
For information about the digital mixing card (DS2416), refer to the owner's manual that comes with the card.
Output from the SW1000XG to the DS2416 digital mixing card
In the initial setting, all parts of the SW1000XG are mixed in stereo and sent to the DS2416.
However, you can send a specific part as an individual output to the DS2416, apart from the
stereo output.
The SW1000XG is equipped with 6 individual outputs and each part (either MIDI multi part
or audio part) can be assigned to any of the individual out 1 to 6, 1+2, 3+4 or 5+6.
For details, see MIDI Data Format tables <1-6> and <1-7>(MIDI Parameter Change tables),
descriptions on "Output Select".
The Output Select can be set using the XGworks' XG Editor Window (The properties dialog
box which opens when clicking on the [DETAIL] button of the part unit). If you are opening
the multi part's properties dialog box, the Output Select can be set in the General page of
the Detail screen.
Make sure that the flat cable is
facing in the correct direction.
Flat cable's
connector
First, put the four spacers in
the SW1000XG, then fit
the plug-in board above
the sound card.
Make sure that
the flat cable from
the DS2416 is
facing in the
correct direction.
SW1000XG sound card
DS2416
Yellow line
Green line Serial out Connector
Serial In Connector
12
SW1000XG sound card
Plug-in board
Spacer