Using Multi Effects - Yamaha MOTIF RACK ES Owner's Manual

Multi mode

Using Multi effects

5.
Set the Effects.
For an application example showing how to use the effects, see
below.
6.
Store the edited Multi.
You can save up to 128 Multis to internal memory. For details about
storing Multis, see page 57.
n Please note that the Multi-part Plug-in Part (17-32) settings cannot be
stored.
CAUTION
When you perform this, the settings for the destination data will be
overwritten. You should always back up your important data to computer
(page 48).
Effect setting flow in the Multi mode
Tone Generator
block
Part 1
Part 2
Part 16
PLG Part
(Multi-part Plug-in
Board)
Parts 17-32
n The Insertion Effects and System Effect are not applied to the Parts of the Multi-
part Plug-in Board.
n The Part Equalizer is not applied to the Parts of Plug-in Board.
Here we'll show an example of editing effect settings in the Multi
Mode.
1.
Select a Multi you wish to edit in the Multi mode
(page 36).
2.
Press the [MULTI] button once or twice to enter the
Mixing Edit mode.
The [MULTI] button LED lights in red.
40
Owner's Manual
The Insertion
RevSend
Effect is
ChoSend
applied to up to
D
eight Parts.
EQ InsEF
A
DryLvl
Using Multi effects
In the final stages of programming and creating sounds, you can
use effects to further enhance and change the character of the
sound — such as by applying a deep, ambient reverb, or by using
chorus to make certain sounds richer and more animated.
When you edit Multi Effect parameters, keep in mind that there are
two different types:
Parameters specific to individual Parts, which include:
D Part Equalizer settings edited in the Multi Part Edit mode
On/off status of Insertion Effects and Send Level settings for
A
System Effects edited in the Mixing Edit mode
Parameters common to all Parts, which include:
B System Effect settings edited in the Effect Edit mode
E Master Equalizer settings edited in the Multi Common Edit
mode
C Master Effect in the Multi Common Edit mode
B
System
Effects
ReverbType
ReverbRtn
ChoToRev
ReverbPan
ChoRtn
ChoPan
ChoCtgry
ChoType
3.
Select the desired Part(s) (up to eight) to which the
Insertion Effects are to be applied (
Use the PAGE [E][F] buttons to select the Effect display and
select the "InsEF" parameter using the cursor [L][M] buttons.
Use the Part/Element buttons ([1/5/9/13]-[4/8/12/16]) to select the
desired Part for the Insertion Effects and checkmark the box using
the data dial.
n The parameter settings of each Insertion Effect are determined in the
Voice Effect Edit of the assigned Voice.
C E
MEF MEQ
Output
).
A