Synchronizing Two Md4S Recorders - Yamaha MD4S Owner's Manual

Multitrack md recorder
Hide thumbs Also See for MD4S:
Table of Contents

Advertisement

94
Advanced recording techniques
Tip: If the measure location of a new step is set earlier than the measure location of an
existing step, the subsequent steps will automatically be reordered. Similarly if you set the
measure location of an existing step to 000 to delete it, the subsequent steps will automatically
be reordered.
MIDI sequencer settings
When using MIDI Clock, you will need to make settings on your MIDI sequencer so that it
will synchronize to MIDI Clock messages. For details on making this setting, please refer to
the owner's manual of your MIDI sequencer.

Synchronizing two MD4S recorders

The MD4S is able to synchronize to MTC received from an external device. For example if you
have two MD4S recorders, and set one MD4S to transmit MTC messages and the other MD4S
to receive these MTC messages, the two units will act as a single 8-track multi-track recorder.
In this case, the MD4S that transmits the MTC will be the MTC Master and the MD4S that
receives the MTC will be the MTC Slave. When the MTC Master MD4S runs, the MTC Slave
MD4S will follow the MTC Master and run in synchronization. In this setup, you can connect
the STEREO OUT jacks of the MTC Slave MD4S to LINE INPUT jacks 5 and 6 of the MTC
Master MD4S so that the signals of the ST bus of both units can be combined by the MTC
Master MD4S.
—Owner's Manual
A 001 4/4
A 001 4/4
A 001 4/4
A 001 4/4
C 008 3/4
Insert
Song
Song
B 008 3/4
Song
B 008 3/4
Delete (
B 008 3/4
)
Song
B 016 5/4
C 016 5/4
C 016 5/4
B 016 5/4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents