Changes in Version 1.1
For information on changes to DME Designer, see the "DME Designer Version 1.2 Owner's Manual."
■ The default gateway IP address is changed.
In Version 1.0, the default IP gateway address was ***.***.***.1, but in Version 1.1, the address is changed to ***.***.***.254.
Consequently, while the zone slave IP addresses in Version 1.0 were ***.***.***.3 through ***.***.***.254, they have changed
in Version 1.1 to ***.***.***.3 through ***.***.***.253.
■ An initialization function has been added.
With this function you can initialize the DME64N/24N and the ICP1.
Turn the power OFF, then turn it back on again while holding down the [SCENE] and [ENTER] buttons.
01. Initialize DME: Returns to the factory setting. (Deletes all user settings except component data.)
02. Delete All Data: Deletes all data.
03. ==> Exit Diag Mode: Leaves this screen and restarts.
■ A THRU connection function has been added.
Even in an environment with no computer, you can check the connections without using DME Designer by directly
connecting the DME64N/24N input/output.
The meter does not operate during a connection check.
This is set on the CHECK page of the utility screen.
MODE: OFF
Makes connections in the configuration used in the current scene.
This is set to OFF when the unit is started.
MODE: Thru
Directly connects the Input and Output of each slot one-to-one for
each channel.
When input-only or output-only cards like AD or DA cards are
inserted in the slots, you cannot perform checks in this mode.
In the DME24N, the internal AD and internal DA are directly
connected on each channel.
2
Notes for DME64N/DME24N Version 1.2
SCENE
SCENE
HOME
HOME
UTILITY
UTILITY
LEVEL
LEVEL
MUTE
MUTE
1. Holding down the [SCENE] and [ENTER] buttons
Plug the PA-300 AC adaptor while holding down
the [SCENE] and [ENTER] buttons.
CANCEL
CANCEL
ENTER
ENTER
2. Press the [POWER] button