Attaching The Rack Mount Adaptor; Air Flow; Attaching The Clamp Filter - Yamaha BBT500H Owner's Manual

Attaching the Rack Mount Adaptor

Attach the supplied rack mount adaptor lets you install the BBT500H in a stan-
dard 19-inch rack.
1. Remove the two screws A on the side of the device and remove the
carrying handle set.
2. Remove the two screws B on the side of the device.
3. Attach the supplied rack mount adaptor to the device using the three
supplied screws C.
* Never use any screws other than the supplied screws C. Using any other screws
can result in damage.
4. In the same manner, attach the other supplied rack mount adaptor to
the opposite side of the device.
5. Keep the leftover screws (A, B) in a safe place for future use.
* Make sure you don't over-tighten the screws when reattaching the carrying handle
to the device. Doing so can result in damage to the carrying handle.

Air Flow

The device utilizes a forced air cooling system, which cools the interior of the unit by drawing air through the front intake by the fan, which
push the air out the back.
Front panel
Intake

Attaching the Clamp Filter

To protect against electromagnetic waves, attach the supplied Clamp Filters to the cable connecting the bass guitar
to the amplifier's INPUT jack, and the cables connecting the amplifier's SPEAKER 1, 2 jacks to the speakers.
* When attaching the clamp filter, wrap the cable once around the clamp filter as close to the BBT500H unit as possible.
Side view
Exhaust
(For U.S. and Canadian models only)
Clamp Filter
Carrying Handle Set
Rack Mount Adaptor
Rear view
Cable
Clamp Filter
B
A
(supplied)
C
Cooling fan
17