Yamaha 02R96 Installation Manual page 13

10
Chapter 2—Windows Installation
Windows XP
Start your computer and Windows, and insert the included CD-ROM into
1
your computer's CD-ROM drive.
Click the Start button, and then click Control Panel.
2
If the Control Panel window appears as shown below, click "Switch to Classic View" on the
left side of the window in order to see all the control panels.
Go to System Hardware–>Driver signatures–>Driver signature options,
3
select "Ignore—Install software without asking for confirmation," and then
click OK.
Click OK to close the System Properties window, and then click the Close but-
4
ton to close the Control Panel window.
Turn off the DM2000/02R96 and use a USB cable to connect the USB TO
5
HOST port on the DM2000/02R96 to a USB port on your computer.
6 Turn on the DM2000/02R96.
The Found New Hardware Wizard appears.
Select "Install software automatically (recommended) (I)," and then click
7
Next.
The driver is installed, and the message "Completing the Found New Hardware Wizard"
appears.
Click Finish, and then restart your computer.
8
Studio Manager for DM2000/02R96—Installation Guide