Table of Contents
Advertisement
Allen Head
Screw
>
Handle Bar
|
FIGURE 3
Leveling
Foot
FIGURE 4
Lock Nuts
. Line up the holes in the handlebar with the holes
in the wheelcover and fasten using four (4) 1/4-
20 allen head screws, washers, and lock nuts.
Tighten using the supplied allen wrench.
. Tilt the scale on its front edge and rest the
handlebar on the floor. Screw a leveling foot into
each corner in the bottom
of the platform
until about 1/4" of thread is showing (Figure 4.)
. Turn the scale upright on its feet and level or
adjust the height of the platform by turning each
footin or out of the platform. Turning the foot into:
the platform will decrease the platform height in
that corner. Turning the foot out of the platform
wil increase the platform height in that corner.
NOTE: Adjust the platform height so that the
platform bottom edge or wheels do not touch the
floor or carpet.
10. Attach the control cable to the bottom of the
control box and clip the cable to the right handrail
with the supplied clips.
11. Clip the power cable to the left handrail with the
supplied clips. Wrap the excess cable around
the control box.
Advertisement
Table of Contents
