Page 1
1554-007, -012, -018 Civacon overfill sensors and 1000RL Civacon retain sensors. These instructions provide a picture overview of additional steps to properly install the FT151RL series and FT152RL sensors into a ROM LINK harness. Installation Steps: Refer to GENDER ADAPTER picture, page 3 1) Remove the Civacon sensor and housing.
Page 2
6) Mount the sensor housing into the manhole cover. 7) Connect the FloTech Gender Adapter to the Civacon harness pig tail for the compartment this sensor is replacing. Use a little dielectric grease or Vaseline in the connector to help repel moisture.
Page 3
9) Next use the provided tie wraps to fasten the pigtail to the main harness as shown in the photo below. These cable ties will ensure the connection is not accidentally pulled apart or damaged. ROM LINK Gender Adapter (Retain and Overfill) 10688PA Rev: D Jun 2021 Page 3 of 4...
Page 4
10) Check all connections. Power up the monitor to check out operation. 11) IMPORTANT NOTICE: Perform a WET TEST on each sensor and look for the corresponding RED sensor LED to light and the permit LED to go out. REMEMBER, to get a Green permissive light, For sales information contact Dixon Bayco In the United States: In Canada:...