Controls & Displays - Secutron MR-2306-AT Series Wiring And Installation Manual

Figure 2
i
Notes: The MR-2306-AT is supplied with NP-386 paper labels for zone identification.
2.1 Controls & Displays
For precise definitions of Control & Display operation, refer to the manual for the Fire Alarm
Control Panel that the Annunciator is being connected to.
Table 2
Controls
System Reset, Signal Silence,
Buzzer Silence, Lamp Test
6
Secure annunciator assembly to MMX-BB-1001D enclosure
This annunciator displays initiating circuit status only (no individual circuit
troubles). Indicating and relay circuits are not remotely displayed. Refer to the
manual of the fire alarm control panel that the annunciator will be connected to.
The MR-2306-AT has a keyswitch to enable the four slide-switch controls. The
key should be appropriately secured.
Controls and Displays
Annunciator
Assembly
4 nuts
Displays
AC On, Common Trouble, Signal Silence,
8 Circuit Status LEDs
BB-1001D