Advertisement
ATTACHING THE STANDS
Stand x 8
Screw x 16
(4 per one speaker)
(8 per one speaker)
When placing the speakers, be sure to use the stands to
increase stability.
Use the 8 specified holes located on the base of the speaker.
4
2
Procedure:
1
Put a screw through the hole on the stand, and screw it
into the speaker at one of the holes on the base of the
speaker.
At this time, screw it untightly so that the stand can still
be moved.
2
Put another screw through the other hole on the stand,
and screw it into the other hole on the base of the
speaker.
3
Tighten both of the screws firmly.
4
Attach a pad to the bottom of the end portion of the
stand.
5
Attach the other stands to the other corners of the base
of the speaker in the same way and confirm that all 4
stands have been firmly attached.
Note
Be carefull not to apply force to the side of the speaker,
otherwise the speaker may fall causing damage to the
speaker or personal injury.
2
E-
Pad x 8
(4 per one speaker)
1
PLACING THE SPEAKERS
I Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.
I Using as main speakers in a multi channel
system
Position the speakers on both sides of the TV. The
positioning of speakers is important, because it controls the
whole sound quality of a multi channel system. Set up the
speakers on the basis of your listening position by following
the owner's manual supplied with your amplifier.
NS-8390
NS-8390
Center
Effect L
Note
These speakers feature a magnetically shielded design,
but there is still a chance that placing them too close to
a TV set might impair picture color. Should this happen,
move the speakers away from the TV set.
Subwoofer
Effect R
Advertisement
