Attaching The Stands - Yamaha NS-555 Owner's Manual

.

ATTACHING THE STANDS

When placing the speakers, be sure to use the stands to
increase stability.
(L)
Stand (R x 2, L x 2)
Pad x4
Note
The provided stands are in two types. Two stands are for the right
side and others are for the left side. Attach each stand to the proper
position on the bottom of the speaker by following the figure
below.
View from the bottom of the speaker
(L)
(R)
Use the 8 specified holes located on the base of the speaker.
2
(R)
Screw
(25mm) x 8
Back
(R)
(L)
Front
Procedure:
1 Put a screw through the inner hole on the stand, and
screw it into the speaker at one of the outside holes on
the base of the speaker. At this time, screw it untightly
so that the stand can still be moved.
2 Put a screw through the outer hole on the stand, and
screw it into the other hole on the base of the speaker.
3 Tighten both of the screws firmly.
4 Attach a pad to the bottom of the end portion of the
stand.
5 Attach the other stands to the other corners of the base
of the speaker in the same way and confirm that all 4
stands have been firmly attached.
Note
Be carefull not to apply force to the side of the speaker, otherwise
the speaker may fall causing damage to the speaker or personal
injury.
Outer hole
Inner hole