Philips CMQ205 - annexe 1 Manual page 5

i
j
• To connect +12V-DC power wire,
ground wire, and remote control
wire.
6
•
Follow all mounting and wiring instructions.
You can mount the amplifier either under a seat
or on the rear tray.
•
To avoid interference, do not place the
amplifier too close to the car audio or antenna.
•
The supplied mounting screws are 25mm long.
Make sure that the mounting board is thicker
than 25mm.
Place the unit on the location for
installation.
Mark the positions of the four screw
holes.
Drill the holes with driller of
approximately 4mm in diameter.
Mount the unit with the supplied screws.