Yamaha HTR-5150 Owner's Manual page 38

PLAYING A SOURCE WITH THE DIGITAL SOUND FIELD PROCESSOR (DSP)
EFFECT
Follow steps 1 to 7 shown in "TO PLAY A SOURCE" on
pages 26 to 27.
Select the desired DSP program that is suitable for the source.
Front panel Remote control
or
Press DSP. While the indicator is lit up for about
three seconds, select a DSP program with the
numeric buttons (1 to 8).
* If the SELECTOR DIAL is set to the DSP position, you can
also select a DSP program directly with the numeric
buttons (1 to 8).
The name of the selected program appears
on the display.
If desired, adjust the delay time and the output level of each
speaker. (See pages 39 and 40 for details.)
The following indicators on the display show you what sound
processing is being undertaken.
1 2 3
1 This lights up in orange when a DVD source encoded with
DTS is played back and DTS is decoded.
2 This lights up in red when an LD source or a CD source
encoded with DTS is played back and DTS is decoded.
3 This lights up when Dolby Digital is being decoded and the
signals of the selected source encoded with Dolby Digital is
not in 2-channel.
4 This lights up when the digital sound field processor is
turned on.
5 This lights up when Dolby Surround is being decoded by
Dolby Pro Logic.
38
4 5
TO CANCEL THE SOUND EFFECT
To cancel the sound effect and monitor only the main sound,
press EFFECT or EFCT ON/OFF. Press EFFECT or EFCT
ON/OFF once more to turn sound effect back on.
Front panel
Notes
• You can select a program for each of the input sources.
Once you select a program, it is linked with the input source
selected at that time. So, when you select the input source
next time, the same program is automatically called up.
• When a monaural sound source is being played with DOLBY
PRO LOGIC or DOLBY PRO LOGIC ENHANCED, no sound
will be heard from the main speakers and the rear speakers.
Sound can only be heard from the center speaker. However,
if the NONE position is selected for "CNTR" in the SET
MENU mode, the main speakers will output the sound of the
center channel.
• When the source of signals input to the EXTERNAL
DECODER INPUT terminals of this unit is selected, DSP
cannot be used.
• If the sound effect is canceled when signals encoded with
Dolby Digital or DTS are input to this unit, the signals of all
channels are mixed and are output from the main speakers.
• If EFFECT or EFCT ON/OFF is pressed to turn the sound
effects off when Dolby Digital or DTS is decoded, it may
happen that the sound is output faintly or not output normally,
depending on the source. In that case, press EFFECT or
EFCT ON/OFF to turn on the sound effects.
If you change the LD (or CD) being played back with DTS
being decoded to another disc that is not encoded with DTS
when the red "dts" indicator lights up, playing back the newly
selected disc will result in no sound output. In this state, the
red "dts" indicator flashes to show that this unit is locked in
the DTS-decoding mode.
To play back the disc normally, change the current DTS-
decoding mode to another mode by INPUT MODE on the
front panel or by INPUT on the remote control so that the red
"dts" indicator goes off.
Remote control
or