Attach The Rear Panel (B); Install The Main Unit (A) - Yamaha Clavinova CVP-103 Reference Booklet

3
• 4 x 12 mm round-head screws 2
• 4 x 20 mm tapping screws 3
42
CVP-109/107/105/103/700
B
C

Attach the rear panel (B).

With the rear panel slightly angled as shown in the illus-
tration, lower it onto the feet's protruding edge at the rear
of the pedal box. Then, while eliminating any gaps be-
tween the rear and side panels, secure the top of the rear
panel to the side panel brackets using two 4 x 12 mm
round-head screws 2. Finally, secure the bottom of the
rear panel to the pedal box using four 4 x 20 mm tapping
screws 3.
V

Install the main unit (A).

Place the main unit (A) on the side panels (D) with the
screws on its bottom panel (toward the rear of the main
unit) just behind the grooves in the brackets located at the
top of the side panels. Then slide the main unit forward
until it stops. WATCH YOUR FINGERS WHEN DO-
ING THIS!!
Align the holes on the bottom panel of the main unit with
the holes in the brackets on the side panels (also center
the main unit to produce equal clearance on the left and
right sides, as shown in the illustration), then screw in and
securely tighten the four 6 x 16 millimeter flat-head
screws 4.
CAUTION
• Do not hold the keyboard in any position other than the position
shown in the above illustration.
• Fingers can become pinched between the main unit and the rear or
side panels, be extra careful so as not to drop the main unit.
4
15 cm
• Be sure to place your hands
at least 15 centimeters from
either end of the main unit when
positioning it.
A
15 cm
D
D