Setting Up The Speakers - Yamaha YHT-693 Owner's Manual

Wall mounting the surround speakers
When mounting the speakers on a wall, attach one of the spacing pads provided near each of the corners on
the rear surface of the speaker to prevent the speaker cable from being caught between the wall and the
speaker.
5-7/8"
(150mm)
When using speaker brackets to mount the speakers
on a wall or celling, it is strongly recommended that
safety wire, which may be included with the bracket, be
used between the speaker and the bracket to prevent
the speaker from falling.
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the "key hole" opening.
WARNING
Each speaker weighs 2.6 lbs (1.2 kg). Do not mount the speakers on thin plywood or a wall with soft surface
material, since the screws may pull away from the surface and fall. This will damage the speakers and can
cause personal injury.
Do not mount the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
Secure installation is the purchaser's responsibility.
4

SETTING UP THE SPEAKERS

2
1
Wall / wall support
Min
7/8"
7/32"
Tapping screw
(Available at the hardware store)