Front effect speakers
How to Connect:
Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are
faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and –
markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or
Red: positive (+)
Black: negative (–)
Unscrew the knob.
Insert the bare wire.
[Remove approx. 5mm
(1/4") insulation from
the speaker wires.]
Tighten the knob and
secure the wire.
Use speakers with the specified impedance shown on the
rear of this unit.
SEE INSTRUCTION MANUAL FOR CORRECT SETTING.
U.S.A., Canada, China, Australia and General models
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
A OR B