Basic Operations; To Play A Source - Yamaha AX-390 Owner's Manual

TO PLAY A SOURCE

1
Set to the "
2
Turn the power on.
3
Select the desired input source by pressing the
corresponding input selector button.
AUX PHONO
* The indicator above the selected button (source) will light
up.
* Note that pressing on each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
8

BASIC OPERATIONS

2
NATURAL SOUND STEREO AMPLIFIER AX-390
POWER
PHONES SPEAKERS
A B
ON ON
OFF OFF
4
∞
" position.
POWER
TUNER CD
3
7
MONITOR
CD DIRECT
TAPE 2 TAPE 1 AUX PHONO TUNER CD
AMP
COPY
VOLUME
BASS TREBLE BALANCE LOUDNESS
7
4
Select the speakers to be used.
* If you use two speaker systems, press both the A and
B switches.
5
Play the source.
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, etc. (refer to page 10).
Notes
If you select AUX, PHONO, TUNER or CD, be sure that
TAPE 1 and/or TAPE 2 are not being selected.
If you select TAPE 1 and TAPE 2 at the same time, the
result will be the sound from the tape deck 1.
For TAPE 1 and TAPE 2, whenever the button is pressed,
the corresponding input source is selected or canceled
alternately.
To turn off the power
Press the POWER switch again.
1, 6
SPEAKERS
A B
ON ON
OFF OFF