Yaesu VX-170 Operating Manual page 59

DTMF P
When you activate the ANI (Automatic Number Identification) feature during DTMF Pager
operation, the DTMF tones stored in ANI memory will automatically be sent whenever
you press the PTT switch. When the ANI is received, the LCD will displays the received
ANI code after the 3-digit DTMF pager code.
Storing the ANI code
1. Press the [ F ] key, then press the [ 0 ( SET )] key, to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 54:
3. Press the [ F ] key momentarily to display any previously-stored ANI code.
4. Press the [ F ] key again to clear any previous ANI code.
5. Rotate the DIAL knob to select the first number/letter (
F
for " "), and
first letter/number and move on to the next character.
6. Repeat the previous step, as many times as necessary (up to 16 characters), to com-
plete ANI code. If you make a mistake, press the [ ( MHz )] key to move back to the
previous letter/number's slot, then re-select the correct letter/number.
7. When you have finished entering the ANI code and it contains less than 16 characters,
press and hold in the [ F ] key for one second to confirm the callsign. (if the ANI code
has exactly 16 characters, you do not need to press and hold in [ F ] in this step).
8. Press the PTT switch to save the settings and exit to normal operation.
You may check your work by monitoring the entered callsign. To do this,
repeat steps 1- 7 above, then press the MONI switch.
Activating the ANI feature
1. Press the [ F ] key, then press the [ 0 ( SET )] key, to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 53:
3. Press the [ F ] key momentarily to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select "
5. Press the PTT switch to save the new setting and activate the
ANI feature.
6. Press the PTT switch to send the DTMF tones stored in ANI
memory after the 3-digit DTMF pager code which is stored in the last-selected DTMF
Pager Memory register.
7. When you receive a ANI code, the LCD will displays the re-
ceived ANI code after the 3-digit DTMF pager code. You may
scroll the received ANI code by rotating the DIAL knob.
8. To disable the ANI feature, just repeat the above procedure, ro-
tating the DIAL knob to select "
VX-170 O
O
AGER PERATION R
(substitute for "#"), then press the [ F ] key momentarily to save the
ON
OFF
M
ANI.WRT
0
ANI .
."
" in step 4 above.
O FTD-7
.
- 9 , A , B , C , D , E (substitute
ANI C
P C F
57