Dtmf Operation; Dtmf Autodialer; To Send The Telephone Number - Vertex Standard VX-110 Operating Manual

Nine DTMF Autodial memories are provided, allowing you to store telephone numbers
for autopatch use. You can also store short autopatch access code streams so as to avoid
having to send them manually.
Here is the DTMF Autodial storage procedure:
Press the [ F ] key, then press the [ M/V ( SET )] key to enter the Set mode.
Rotate the DIAL to select Menu Item #26 ("
Press the [ F ] key to enable adjustment of this Menu item.
Rotate the DIAL to select the DTMF Memory register ("
you wish to store this DTMF string.
Press the [ F ] key, then press the [ F ] key again, to begin DTMF Memory entry into the
selected register.
Rotate the DIAL to select the first digit of the desired telephone number. When you
have made your selection, press the [ ] key momentarily to move to the next digit.
Repeat the previous step to program the remaining numbers of the desired number. A
total of 16 digits may be used in the creation of a telephone number.
Press the [ F ] key, then press the PTT switch to save the setting. To store other numbers,
repeat this process, using a different DTMF memory register.

To send the telephone number:

Press the PTT switch to begin transmission.
Press the [ ] or [ ] key, to select the DTMF Memory ("
number is stored that you wish to dial.
Press the [ REV ( DTMF ) ] key to begin sending the DTMF string. Once the string be-
gins, you may release the PTT key, as the transmitter will be held "on the air" until the
DTMF string is completed.
VX-110 O
PERATING
DTMF A
M
ANUAL

DTMF Operation

UTODIALER
").
" through " ") into which
" to " ") in which the
25