Spectrum Scope; About The Spectrum Scope; Explanation Of The Function Keys On The Spectrum Scope Screen - Yaesu FTDX-9000 Operation Manual

S
PECTRUM
This page displays the Spectrum Scope which is con-
venient for monitoring band activity.
The entire screen will become the spectrum display,
and you can see both strong and weak signals clearly
and easily. Not only the Main (VFO-A) is shown, but
the spectrum of the Sub (VFO-B) side can be also
switched in and displayed simultaneously.
Besides simultaneous display of the Main (VFO-A)
and Sub (VFO-B) spectra, the LBWS function allow
you to realize very high-speed signal detection over
a limited band segment. The CTR mode let you moni-
tor close by your current frequency (your frequency
is located at the center of the screen), and the FIX
mode can also be engaged, whereby the left edge
frequency is fixed. These features have been care-
fully considered for their utility in actual Amateur Ra-
E
XPLANATION OF THE
Below you will find the explanation of the function keys utilized while the Spectrum Scope is displayed. Depend-
ing on the individual screen in use, the functions of the function keys located just below the TFT screen varies.
Please confirm the function displayed on the screen during operation.
[ F1 ]( FUNC )
Moves you to the function screen of the Spectrum
Scope used for setup of the MKR (Marker) func-
tion, etc.
Advice: On this screen, the functions assigned
to the function keys can be changed. If you want
to go back to the previous screen, press the
[ F7 ]( EXIT ) key.
Page 12
S
COPE
A S
BOUT THE
F K
UNCTION EYS ON THE
S
PECTRUM COPE
dio operation.
If the Spectrum Scope is not currently displayed, press
the [ DISP ]( DISPLAY ) key momentarily as many times
as needed to bring up the Spectrum Scope display
screen.
Advice: The Spectrum Scope function of the
FT 9000 is a very intelligent capability, and it includes
DX
a wide array functions; if you lose your way during
operation of this function, press the [ DISP ]( DISPLAY )
key momentarily to change the screen, and then re-
turn again to the Spectrum Scope screen.
Quick Point: The vertical axis of the Spectrum Scope
is 10 dB per division.
During transmission, the transmitter's waveform will
be displayed.
S
PECTRUM
[ F2 ]( SPAN ) "Bandwidth"
By pressing this key momentarily, it is possible to
set the range of frequencies from the left edge to
the right edge. If the setting is toggled to 2500
kHz, and you press this key once more, the span
returns to 25 kHz again. At the top of the screen,
the current span is indicated below the span indi-
cation.
FT 9000 TFT O
S S
COPE CREEN
M