Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
wrench
, and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M8 Locknut
(63)–4
M4 x 16mm
M4 x 16mm
Round Head
Screw (67)–9
Screw (95)–4
M8 x 13mm
Patch Screw
(62)–8
M8 Split
Washer (80)–8
Washer (79)–10
M4 x 30mm
Screw (74)–4
M8 x 25mm Flat
Patch Screw
(68)–6
.
M10 Split
M10 Washer
(64)–4
M6 x 13mm
Patch Screw
(78)–8
M8 x 45mm Button
Bolt (70)–4
5
, an adjustable
23mm x 19mm
Wave Washer
(76)–4
M6 x 32mm Patch
Screw (96)–4
M10 x 19mm Patch
Screw (61)–14
Advertisement
Table of Contents
