Cub Cadet 2166 Operator's Manual page 53

Cub cadet tractor operator's manual 2000 series
Hide thumbs Also See for 2166:
Table of Contents

Advertisement

—Before Each Use
1. Engine filler cap and
dipstick
2. Transmission oil level
and fill port
—After Every 10 Hours of Operation
3. Steering knuckles (2)
(both sides)
4. Transmission oil filter
5. Front axle pivot bolt
6. Foot and lift control
pivot points
7. Deck spindles
8. Spindle belt idler arm
—After Every 30 Hours of Operation
9. Front wheel bearings
10. Steering gear
housing (2)
—After Every 50 Hours of Operation
11. Transmission oil filter
12. Deck front gauge
wheels
13. Deck double pulley
—After Every 100 Hours of Operation
14. Transmission oil filter
15. Engine oil drain valve
and oil filter
Lubrication information for optional equipment may be found in the manual which is included with the
specific piece of optional equipment.
LUBRICATION GUIDE
Check the oil (with the engine stopped) and add sufficient new oil to bring it to
the "FULL" mark on the dipstick. Do not overfill. Do not operate the engine if
the oil level is below the "LOW" mark on the dipstick.
Check the oil with the engine stopped. Keep the lubricant up to the "FULL"
mark on the dipstick.
NOTE: The transmission oil level and fill port services the following:
1. Rear axle
2. Hydrostatic transmission
Use 251H EP grease or an equivalent No. 2 multi-purpose lithium grease and
apply sufficient grease to flush out old grease and dirt.
NOTE: After the first 10 hours only, remove the transmission oil filter and
replace with a new filter. Refer to "MAINTENANCE." Change the transmission
oil filter after 50 hours and every 100 hours of operation thereafter.
Use 251H EP grease or an equivalent No. 2 multi-purpose lithium grease and
apply sufficient grease to flush out old grease and dirt.
Use a liberal amount of high grade lubricating oil.
Use 251H EP grease or an equivalent No. 2 multi-purpose lithium grease and
apply 2 strokes (minimum) or sufficient grease to flush out old grease and dirt.
Use 251H EP grease or an equivalent No. 2 multi-purpose lithium grease and
apply 2 strokes (minimum) or sufficient grease to flush out old grease and dirt.
Two or three strokes minimum of the lubricator using 251H EP grease or an
equivalent No. 2 multi-purpose lithium grease.
Every 30 hours or three times a season, use 251H EP grease or an equivalent
No. 2 multi-purpose lithium grease. Apply two strokes with lubricator.
NOTE: After the first 50 hours only, remove the transmission oil filter and
replace with a new filter. Refer to "MAINTENANCE." Change the transmission
oil filter every 100 hours of operation thereafter.
Use 251H EP grease or an equivalent No. 2 multi-purpose lithium grease and
apply sufficient grease to flush out old grease and dirt
Use 251H EP grease or an equivalent No. 2 multi-purpose lithium grease and
apply sufficient grease to maintain lubrication.
Change the transmission oil filter and replace with a new filter. Refer to
"MAINTENANCE."
While the engine oil is warm, open the drain valve and remove the oil filter, and
drain all of the oil from the crankcase. Close the drain valve. Refer to
"MAINTENANCE," "FILLING THE CRANKCASE" and "OIL FILTER" for
proper oil filling procedure. Refer to "LUBRICATION TABLE" for the proper
quantity and viscosity to use.
NOTE
53

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents