Lubrication Table - Cub Cadet 2166 Operator's Manual

Check
Point of
Lubrication Hours
Engine crankcase Check
before
each
use
Hydro transmission Check
and transaxle with before
filter each
use
Steering knuckles
and front axle
pivot bolt
Front wheel
bearings
Steering gear
housing
Deck spindles
Spindle belt
idler arm
Deck Double Pulley
Deck front gauge
wheels
Foot and lift con-
trol pivot points

LUBRICATION TABLE

Change
at at Capacity
Hours
100 Approx.
4 pints
Add as Approx.
needed 6 qts
10
30
30
10
10
50
50
10
Anticipated Air Temperature
Above + 32°F
Cub Cadet
Engine Oil SAE
10W30 or 10W40
Cub Cadet Drive System Fluid Plus
NOTE: Cub Cadet Drive System Fluid Plus is specially
formulated for this application. If any other oil is used
Cub Cadet will not be responsible for substandard
performance. Failures due to use of improper fluid
are not covered by warranty. For maximum protec-
tion, use Cub Cadet Drive System Fluid Plus.
Use 251H EP grease or equivalent No. 2 multi-
purpose lithium grease and apply two strokes
(minimum) or sufficient grease to flush out old
grease and dirt.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Use 251H EP grease or equivalent No. 2 multi-purpose
lithum grease. Do not over lubricate.
Use 251H EP grease or equivalent No. 2 multi-purpose
lithum grease.
Use a liberal amount of high grade lubricating oil.
51
Below + 32°F
Cub Cadet
Engine Oil SAE
5W20 or 5W30