Printing Safety Guidelines - Xerox Phaser 3500 User Manual

Your attention to the following safety guidelines helps to ensure the continued, safe operation
of your printer.
Printer Supplies
Use the supplies specifically designed for your printer. The use of unsuitable materials
may cause poor performance and a possible safety hazard.
Follow all warnings and instructions marked on, or supplied with, the printer, options and
supplies.
Printer Location
Place the printer in a dust-free area where the temperature range is 50 degrees F to
89 degrees F (10 degrees C to 32 degrees C) and the relative humidity range of 20 percent
to 80 percent.
Place the printer in an area where there is adequate space for ventilation, operation, and
servicing. The recommended minimal spacing is 32 cm (12.6 in.) behind and 10 cm (4 in.)
on each side of the printer.
Do not block or cover the slots and openings on the printer. The printer may overheat
without adequate ventilation.
For altitudes under 2,050 meters (6,726 ft.), use the Low Altitude setting. For altitudes
over 2,050 meters (6,726 ft.), use the High Altitude setting.
Do not place the printer near a heat source.
Do not place the printer in direct sunlight.
Do not place the printer in line with the cold air flow from an air conditioning system.
Place the printer on a level, solid surface with adequate strength for the weight of the
printer. The base printer weight without any packaging materials is approximately 17 kg
(38 lb.).
Moving the Printer
Refer to "Moving and Repacking the Printer" on page 41.

Printing Safety Guidelines

Wait 10-15 seconds between turning the printer off and on.
Keep hands, hair, neckties, etc., away from the exit and feed rollers.
Do not remove the paper source tray that you selected in either the printer driver or control
panel when the printer is printing.
Do not open the doors when the printer is printing.
Do not move the printer when the printer is printing.
Phaser® 3500 Laser Printer
46
A–User Safety