Controller hardware specifications and requirements summary
Dimensions (depth,
Device
width, height)
Processor
d=17.5 in. / 44.5 cm
w=17.5 in. / 44.5 cm
h= 5 in. / 12.7 cm
Monitor
d=21 in. / 53.3 cm
w=19 in. / 48.3 cm
h=21 in. / 53.3 cm
4 mm cartridge
d=12.25 in. / 31 cm
tape drive
w=7.5 in. / 19 cm
h=2.75 in. / 7 cm
Keyboard
d=7.5 in. / 19.1 cm
w=20 in. / 50.8 cm
Mouse
d=3 in. / 8 cm
w=4 in. / 10 cm
h=2 in. / 5 cm
XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODEL 92C NPS
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
The following table summarizes the specifications and electrical
requirements of your DocuPrint NPS printer controller hardware
components.
For a summary of printer hardware specifications and requirements,
refer to the "Printer specifications and requirements" chapter of this
guide. Contact your service representative if you have questions not
specifically addressed in this guide.
Table 5-4.DocuPrint Model 92C NPS printer controller
specifications and power requirements
Heat
Weight
dissipation
27 lbs. /
1,100 BTU
12.7 kgs
per hours
61 lbs. /
408 BTU
27.7 kg
per hour
8 lbs. /
---
6.6 kg
2 lbs. / 1kg
---
0.3 lbs. /
---
0.14 kg
Power requirements
Sun Ultra 2 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
Sun Ultra 2 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
Sun Ultra 60 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
Sun Ultra 60 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
100-120 ~ VAC,
1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 ~ VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4 KVA
100-120/200-240 VAC,
0.8/0.4 amp, 47-63 Hz
---
---
Cable lengths
Power: 8 ft. /
2.4 m
Interface to
printer:
20 ft. / 6.1 m
usable length
Video cable to
processor:
46 in. / 1.17 m
SCSI cable to
processor or
additional SCSI
device:
28 in. / 71 cm
72 in. / 1.8 m
25 in. / 63 cm
5-7