Continuous Form To Cut Sheet Conversion - Xerox DocuPrint 180 Solution Manual
Xerox docuprint 180: supplementary guide
Hide thumbs
Also See for DocuPrint 180:
- Message manual (356 pages) ,
- Configuration manual (276 pages) ,
- System configuration manual (132 pages)
Table of Contents
Advertisement
IPS APPLICATION MIGRATION
Continuous form to cut sheet conversion
4-14
If you try to print the same application on both an IBM 3800 printer
(continuous form) and a DocuPrint IPS printer (cut sheet), your
output may appear in the wrong orientation or extend off the edge of
the page. These problems occur because the page origin on the IBM
3800 printer is different from all other IPDS printers, including the
DocuPrint IPS printers:
•
for DocuPrint IPS printers and all other cut sheet printers (both
IBM and Xerox), the origin is at the top left corner of a portrait
page
•
for IBM 3800 printers, the origin is at the top left corner of the
leading edge.
As a result, you may need to modify your existing AFP resources to
account for this difference, whether you are changing from a 3800 to
another IBM continuous feed printer, such as the 3900 or 3835, or to
any IBM or Xerox cut sheet printer.
The required changes are based on the current page rotation and
presentation specified in the FormDef or PageDef for documents
printed on continuous form printers. For example, if you have
documents that use 11 by 17 inch paper, you may need to change
the rotation in order to print the application correctly.
Another option is to use the 90° rotation feature on the DocuPrint IPS
printers. This allows the print operator to rotate the print 90° and
allows it to print correctly, without having to make any application
changes.
This figure illustrates the difference between the two page origins:
Converting 3800 applications
Continuous forms are fed into a 3800 printer either of two ways: wide
feed (long edge first) or narrow feed (short edge first). While the
DocuPrint IPS printers feed the paper long edge first (wide feed), the
orientation is based on a narrow feed. Therefore, if you are migrating
an application originally created for the IBM 3800 that uses narrow
forms, you should not have to make any changes to your AFP
resources because the 3800 hardware origin will match the
DocuPrint IPS origin.
DOCUPRINT IPS SOLUTIONS GUIDE
Advertisement
Table of Contents
