Xerox Phaser 8560 User Manual page 88

5. On the control panel, press the OK button if the correct paper size and type are displayed
as the current setup, or select
■ If your custom paper size is displayed in the list, select it, and then press the
OK button. Go to Step 8.
■ If your custom paper size is not displayed in the list, select
then press the OK button.
6. Select one of the following Short Edge options:
Press the OK button if the correct short edge size is displayed as the current setup.
■
■ Select , and then press the OK button to enter a new short edge size. Press the
Change
Up Arrow and Down Arrow buttons to specify the short edge size, and then press the
OK button.
7.
Select one of the following Long Edge options:
■ Press the OK button if the correct long edge size is displayed as the current setup.
■ Select , and then press the OK button to enter a new long edge size. Press the
Change
Up Arrow and Down Arrow buttons to specify the long edge size, and then press the
OK button.
8. Select the appropriate paper type, and then press the OK button.
9.
In the printer driver, select Tray 1 as the paper source.
Note:
When you define a new custom size, it is stored in the printer so it can be used again.
Up to five custom sizes can be stored in the printer. If you define a new custom size after five
custom sizes have been stored, the new custom size replaces the least recently used.
, and then press the OK button.
Change setup
Phaser® 8560 Color Printer
3-58
Printing on Specialty Media
New Custom Size , and