Customizing Your Workcentre; Programmable Features - Xerox WorkCentre XD100 User Manual

Customizing Your WorkCentre

Programmable Features

The default settings for various machine features may be changed to suit
your individual needs. All of these features remain set until this process is
repeated.
Each of the programmable features, along with its program number and
options are contained in the chart below. The procedure to change the
default settings follows the chart.
Note: The procedures written in this manual are based on the factory
default settings.
Priority Tray: This feature allows you
to set the default paper tray. At power
on or auto clear, the copier will return
to the selected priority paper tray.
(Model XD104/105f/120f//130df/155df
only.)
Auto Clear Time Out: This feature
allows you to select the time it takes
for the copier to return to the normal
copy mode after a copy cycle is
complete.
Time Out to Power Save: When
enabled, this feature automatically
reduces power used by the copier if
the copier has not been used for the
set period of time.
Time Out to Power Shut-Off: When
enabled, this feature significantly
reduces power used by the copier if
the copier has not been used for the
set period of time.
Default Magnification: This feature
allows you to make copies slightly
larger or smaller than the original, or
the same size.
28
Feature Program Option Number
Number * Factory Setting
0 0 – Main paper tray *
1 – Alternate paper
tray
2 - Second paper
tray
1 0 – Off
1 – 30 seconds
2 – 60 seconds *
3 – 90 seconds
4 – 120 seconds
2 0 – Off
1 – 45 seconds
2 – 90 seconds *
3 – 2 minutes
4 – 5 minutes
3 0 – 2 minutes
1 – 5 minutes *
2 – 15 minutes
3 – 30 minutes
4 – 60 minutes
5 – 120 minutes
6 – Off
4 0 – 100% *
1 – 99%
2 – 101%