Calibrating The Scanner - Xerox WorkCentre 6400SFS User Manual

Calibrating the Scanner

Calibrate the scanner after you replace the scanner or document feeder. When you calibrate the
scanner, the printer scans the calibration page and adjusts the output quality of the front and back
pages of 2-sided originals in relation to each other.
Note: You do not need to calibrate the scanner regularly. Only calibrate when you have replaced
the scanner or the document feeder.
The scanner must be calibrated using the document glass and the document feeder.
To calibrate the scanner:
1. Start the calibration procedure from the printer's control panel.
2. Log in as a system administrator. Press the Log In/Out button (user name: admin, default
password: 1111).
3. On the control panel, press the Machine Status button.
4. Select the Tools tab.
5. Select Troubleshooting, then Calibration.
6. Select Document Glass Registration.
7. Place the scanner calibration page on the document glass. The scanner calibration page is included
with your replacement scanner or document feeder.
8. Close the document feeder.
9. On the control panel, select Start to scan the calibration page.
10. Wait for the scan to be completed, and then select one of the following options:
• If the control panel indicates Success, select Close, and continue with Step 11.
• If the control panel indicates Failure, select Close, and repeat Steps 7–9.
6400-173
WorkCentre 6400 Multifunction Printer
Maintenance
171
User Guide