Laser Safety; Maintenance Safety; Operational Safety - Xerox Phaser 6128MFP User Manual

The power cord is attached to the printer as a plug-in device at the back of the printer. If it
is necessary to disconnect all electrical power from the printer, disconnect the power cord
from the electrical outlet.
Warning: Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are specifically instructed to do so. Power should be OFF
when performing these installations. Except for user-installable options, there are no parts
that you can maintain or service behind these covers.
Note: Leave the printer on for optimum performance; it does not pose a safety hazard. If
however the printer will not be used over an extended period of time, it should be turned
off and unplugged.
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the printer.
• The printer is exposed to water.
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
Caution:
To reduce the risk of fire, use only No. 26 American Wire Gauge or larger
telecommunication line cord.

Laser Safety

With specific regard to lasers, this printer complies with laser product performance
standards set by governmental, national, and international agencies and is certified as a
Class 1 Laser Product. The printer does not emit hazardous light because the beam is
totally enclosed during all modes of customer operation and maintenance.

Maintenance Safety

• Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
• Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
• Do not attempt to open, reuse, or burn any consumables or routine maintenance items.
For information on Xerox supplies recycling programs, go to www.xerox.com/gwa.

Operational Safety

Your printer and supplies were designed and tested to meet strict safety requirements.
These include safety agency examination, approval, and compliance with established
environmental standards.Your attention to the following safety guidelines helps to ensure
the continued, safe operation of your printer.
Phaser® 6128MFP Multifunction Printer
10