Problem Solving Charts; General - Xerox XDL23 User Manual

Problem
(XDL23/XDL33)
The Ready to copy indicator light does not
come on.
(XDL33D)
The message Ready to copy or Press Start
to continue does not appear.
Copies are not copied on the desired paper
size.
XDL23/XDL33/XDL33D User Guide

Problem solving charts

The problem solving charts list copier problems that may occur
and their suggested solutions.
Follow the suggested solutions until the problem is corrected. If
the problem persists, call for service.
The following charts are available:

General

Suggested solutions
Ensure the power cord is plugged into the receptacle
correctly.
Ensure the power switch is set to the on position.
Check that the GFI is in the on position and try
resetting.
Ensure the power cord is plugged into the receptacle
correctly.
Ensure the power switch is set to the on position.
Check that the GFI is in the on position and try
resetting.
If the Auto option is selected in paper supply, then:
Clean the document glass.
Clean the underside of the document cover, or the
ADF/DADF belt.
If your original is a transparency, place a sheet of
white copy paper over the original.
If the Auto option is not selected in paper supply, then:
Ensure the original is correctly positioned against the
registration guide on the document glass.
Select the desired paper tray and reduce/enlarge
ratio, press the Start button.
General
Misfeeds
Copy quality
Problem solving
83