Xerox Document Centre 220 User Manual page 241

Symptom
Blank output
Paper sometimes folds over when it is
delivered to the Finisher
Xerox Document Centre 220/230/332/340 User Guide
Recommendation
À
Check to see if the document is loaded
face up in the Document Feeder.
À
If the Copy/Print Cartridge is new, the
toner might not be dispensed. Repeat
the job.
À
Check to see if the seal tape is
removed from the new Copy/Print
Cartridge.
À
Reinstall the Copy/Print Cartridge.
À
Replace the Copy/Print Cartridge.
À
When using paper longer than 8 1/2" x
11", select the Center Output Tray
instead of the Finisher. To staple the
output, begin by pressing and then
releasing the button on the top edge of
the Finisher. A green light is displayed.
(If a job is currently in process, the light
will flash. Wait until the job finishes and
then try again.) Looking at the Finisher
from the left end of the machine, you
will see an imprint of a staple next to a
green tab, above the Left Tray. Slide
the document toward the stapler, over
the green tab, until you hear the click of
the Finisher inserting the staple.
Page 10-7