Scanning Setup; Step 1 Designate Scanning Account - Xerox Document Centre 220 Getting Started

S S
CANNING ETUP
The following setup outlines the basic setup procedure for scanning. Refer to the
Xerox Document Centre 220/230/332/340 ST or 230 LP System Administration
Guide for complete scanning setup details. This setup is part of a four step
process, which is discussed in this section.
There are two other ways to perform scanning setup. These procedures may be
performed using native network tools or CentreWare Scanning Services (when
available).
À
To set up the Scan Service the following general steps must be performed:
1. Designate the scanning account on a file server using native network tools.
2. Create scanning repositories on a file server using native network tools.
3. Create template pools on a file server using native network tools.
4. Create or modify templates using Internet Services.
5. Optionally, install Visioneer PaperPort on the workstation.
S 1 D
TEP ESIGNATE
Using your native network application, create a scanning account for scanning
use. Also, create repositories for scanned documents. A template pool can
additionally be created.
G S I
ETTING TARTED WITH NTERNET
S A
CANNING CCOUNT
S
ERVICES
S U I
ETTING P NTERNET
Setting Up for Scanning
S
ERVICES
2-7