Output - Xerox CopyCentre C32 Quick Reference Manual

Spode QRG.book Page 4 Tuesday, May 13, 2003 10:51 AM

Output

Output is used to select the finishing requirements for the job. The options will
depend on the finishing output device available.
Options:
Select Collated for output stacked in sets to match the sequence of the originals.
C
OLLATED
Select Uncollated for output sorted into stacks of individual pages.
U
NCOLLATED
The above output will be delivered in one of the following depending on the output
tray:
W
ITH
W
ITHOUT
Available if the CopyCentre/WorkCentre Pro is equipped with the 2000 Sheet
S
TAPLED
Stacker/Stapler. It offers a selection of single or double stapling options. Collated
and uncollated stapled sets will be delivered offset in the finisher.
i
Staples 2 - 50 sheets. The 50-sheet maximum applies to up to 24lb / 90 gsm
paper.
P 3-4
AGE
Each copy set will be slightly offset to allow easy separation.
O
FFSET
The copy sets will not be offset.
O
FFSET
X C C /W
EROX OPY ENTRE
C P 32/40 C Q
ORK ENTRE RO OLOUR
R G
UICK EFERENCE UIDE