Output Quality - Xerox CopyCentre C32 Quick Reference Manual

Spode QRG.book Page 7 Tuesday, May 13, 2003 10:51 AM

Output Quality

Stray marks or black marks from hole punched originals are not
removed
Use the Edge Erase to erase the edge with the drilled holes.
Copy from the document glass with the Document Cover down.
Images are out of sequence or upside down when the Booklet
Creation Feature is used
Ensure that the originals are in the correct sequence.
Feed LEF originals to SEF orientated paper stock.
Enable the display options for Booklet Creation and ensure that the correct
sequence is selected (i.e.Left to Right or Right to Left).
The output is blank
Ensure the originals are loaded either face up in the Document Handler or face
down on the Document Glass.
Streaks, lines, spots, or black, solid, or dotted lines on the prints
Run the job from the Document Glass.
Check the quality of the original. Use Border Erase or Edge Erase to remove
lines from the edges of the document.
Turn on Background Suppression.
Load fresh paper.
Image Loss
When copying a document from a larger paper size to a smaller size, use Auto%
to reduce the image onto the smaller size.
Use reduction i.e., copy at 90% instead of 100%.
Select [Auto Center] and run the job again.
If scanning from the Document Glass, select [Manual Platen Input] and define
the document size. Register the document in the right rear corner and copy with
the cover down.
Blurred images on output
Load fresh paper.
X C C /W C
EROX OPY ENTRE ORK
P 32/40 C Q
ENTRE RO OLOUR UICK
R G
EFERENCE UIDE
P 10-7
AGE