Test Access - Xerox CopyCentre C118 System Administration Manual

11 CentreWare Internet Services
9.
Select [Enable] by selecting [ ] or [ ] and then press the <Enter> button.
Next, establish TCP/IP.
1.
Press the <Exit> button once or twice to display the [Network/Port] screen.
2.
Select [TCP/IP Settings] by selecting [ ] or [ ] and then press the <Enter>
button.
3.
Select [Get IP Address] by selecting [ ] or [ ] and then press the <Enter>
button.
4.
Select [DHCP/Autonet], [DHCP], [BOOTP], [RARP], or [Manual] by selecting [ ]
or [ ] and then press the <Enter> button.
NOTE: Use the DHCP server together with the Windows Internet Name Service
(WINS) server.
If you selected [Manual] in step 4, use the following steps to enter the IP address.
If you selected other than [Manual], press the <Login/Out> button and then go to Test
Access on page 94.
1.
Press the <Exit> button.
2.
Select [IP Address] by selecting [ ] or [ ] and then press the <Enter> button.
3.
Use the numeric keypad to enter the IP address in the format "xxx.xxx.xxx.xxx".
NOTE: Press the < > button to move to the next section. Press the < > button to
return to the previous section.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format.
4.
Press the <Enter> button.
5.
Press the <Exit> button.
6.
Use the same steps as IP address setting to enter the subnet mask and gateway
address.
NOTE: You can enter 000, 128, 192, 224, 240, 248, 252, 254, or 255 into each section
as the values for the subnet mask.
NOTE: You cannot enter 127, 254, or 255 into the first section of the format for the
gateway address.
7.
Press the <Log In/Out> button.
NOTE: If you wish to filter access to the machine from the client computers, activate
the IP Filter. The [Filter] screen is located in the same layer as the [TCP/IP Settings]
screen.

Test Access

Follow the steps below to access CentreWare Internet Services.
1.
At a client workstation on the network, launch an internet browser.
94 Xerox CopyCentre/WorkCentre 118 System Administration Guide