Fax/Internet Fax Procedure; Load The Documents - Xerox CopyCentre 133 User Manual

4 Fax/Internet Fax
the required country. After saving the settings, the machine reboots automatically. For
more information, refer to Other Settings on page 200
NOTE: This setting is only available with the Fax option for the countries stated above.

Fax/Internet Fax Procedure

This section describes the basic procedure for sending faxes and Internet Faxes Follow
the steps below.
1. Load the Documents - page 78
2. Select the Features - page 79
3. Specify the Destination - page 79
4. Start the Fax/Internet Fax Job - page 80
5. Confirm the Fax/Internet Fax Job in the Job Status - page 80
Stop the Fax/Internet Fax Job - page 81
NOTE: If the Authentication feature is enabled, you may need an account number
before using the machine. To get an account number or for more information, contact
the Key Operator.
NOTE: For information on using Direct Fax from PC clients, refer to Fax Driver On-line
Help on the CentreWare CD-ROM.

1. Load the Documents

The following steps explain how to load documents using the document feeder. When
sending a fax, you can scan up to 600 mm (23.5 inches) in length (single-sided mode).
You can also use the document glass to send documents if required.
This machine is capable of scanning mixed size originals, using the document feeder.
Align the documents against the inner corner of the document feeder; and enable the
Mixed Size Originals feature. For more information, refer to Mixed Size Originals on
page 92.
1.
Load documents face up into
the document feeder or face
down on the document glass.
NOTE: The long fax document scan feature has the following limitations.
• Only available when using the document feeder.
• Allows you to scan up to 600 mm (23.62 inches) in length.
78 Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide