Setups; System Settings Procedure; Entering The System Settings Mode - Xerox CopyCentre 133 User Manual

11 Setups

This chapter, aimed for the Key Operator, describes how to change various defaults
preset on the machine, how to register various items such as mailboxes and
destinations, and how to configure or change Key Operator settings.

System Settings Procedure

This section describes the basic system settings procedure. Follow the steps below.
1. Entering the System Settings Mode – page 189
2. Customizing the Settings – page 190

1. Entering the System Settings Mode

1.
Press the <Log In/Out> button
on the control panel.
2.
Enter the correct user ID using
the numeric keypad on the
control panel or the screen
keyboard. For information on
keyboard entry, refer to
Keyboard in the Fax/Internet
Fax chapter on page 83.
NOTE: The default Key Operator ID is "11111". If the Authentication feature is
enabled, you may be also required to enter a password. The default password is "x-
admin". To change the default user ID or password, refer to System Administrator
Settings on page 256.
3.
Select [System Settings] on the
[System Administrator Menu]
screen.
NOTE: In [User Mode], you can
operate the machine normally while
logged in as the Key Operator.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide
<Log In/Out>
button
189