Installation; Cleaning And Maintenance - DHG Dyna-Form Overlay Superior Instructions For Use Manual

Installation

The mattress should only be installed and used by a clinician or a trained lay operator. A lay operator shall be considered trained once they have
fully read this user manual.
Remove all packaging and protective material. Avoid using any sharp instruments to remove this packaging as this could damage the cover. If the
mattresses has not been delivered vacuum packed, it can be used immediately. If the mattresses has been delivered compressed and vacuum
packed, it is advised that the mattress should lay unpacked, on a flat surface, for at least 2 hours before it is used.
Place the Dyna-Form Overlay Superior on top of the lower mattress and use the four (4) elastic straps located in each corner of the mattress to
secure the overlay to the lower mattress. It is extremely important that the overlay is secured to the lower mattress in this fashion prior to a user
lying on the mattress.
Typically, the user will be placed in a supine position on the mattress.
Wipe the mattress down before covering the mattress with a loose-fitting sheet.

Cleaning and Maintenance

Mattress cleaning should take place before and after use, and between patients.
In the Case of Light Soiling
In the absence of gross contamination or unusual risk, the removal of dirt and spillages with clean, warm water and neutral detergent should be
sufficient. However if required the cover can be wiped down with a solution of Sodium Hypochlorite diluted to 1,000ppm available chlorine. Ensure
that the cover is rinsed with clean water using a single use non-abrasive cloth, and thoroughly dried. Ensure adequate ventilation.
In the Case of Heavy Soiling
In cases of gross contamination the mattress cover should be cleaned first with detergent and water then with a solution of Sodium Hypochlorite
diluted to 10,000ppm available chlorine. Rinse well with clean water and a damp single use non-abrasive cloth. Ensure adequate ventilation.
Machine Laundering
If required, the Mattress Cover may be removed and machine-washed at a temperature of 80°C, for not less than 10 minutes.
Drying
To avoid shrinkage of the cover line dry in an indoor clean environment or tumble dry on a low heat setting not exceeding 40°C and for not longer
than 10 minutes. Covers must be thoroughly dried before re-fitting to the mattress.
Maintenance
Inspect the inner and outer surfaces of covers, the seams, and zips regularly for signs of damage. If the cover is stained, soiled or torn, the foam
core should also be examined.
It is recommended that an audit of all mattresses is carried out annually.
Re-Use, Storage and Disposal
Re-Use
The product is reusable. Before using the product again with a new user, it is recommended to clean the product using the above instructions.
Storage
It is advisable to store the mattress off the floor in a clean, dry environment. It is advisable to store the mattress flat. Do not store the mattress near
heating devices. Do not store the mattress where it might be prone to damage.
Disposal
All contaminated mattresses must be disposed of as clinical waste in accordance with regional regulations and local legislation and guidelines.
5 IFU