Download Print this page
X10 VK70A Owner's Manual
X10 VK70A Owner's Manual

X10 VK70A Owner's Manual

Indoor/outdoor wide angle color camera with built-in 2.4 ghz wireless transmitter, plus x10 controlled power supply, and video receiver

Advertisement

Quick Links

Indoor/Outdoor Wide Angle Color
Camera with Built-in 2.4 GHz
Wireless Transmitter, plus X10
controlled power supply, and
Video Receiver.
OWNER'S MANUAL
VR36A
XC19A
XM13A
M
VK70A
ODEL
(
XC19A W
E
C
INCLUDES
IDE
YE
,
VR36A V
POWER SUPPLY
AND
IDEO
, XM13A
AMERA
ADDRESSABLE
R
)
ECEIVER

Advertisement

loading

Summary of Contents for X10 VK70A

  • Page 1 Indoor/Outdoor Wide Angle Color Camera with Built-in 2.4 GHz Wireless Transmitter, plus X10 controlled power supply, and Video Receiver. OWNER'S MANUAL VR36A XC19A XM13A VK70A ODEL XC19A W , XM13A INCLUDES AMERA VR36A V POWER SUPPLY IDEO ECEIVER ADDRESSABLE...
  • Page 2: Table Of Contents

    Also included is a remote controlled power supply, Model XM13A, which lets you turn the camera on and off by remote control from any X10 remote control (sold separately). You can purchase additional cameras and power supplies so you can have a multiple camera system. You can then set all cameras to the same channel as the receiver and turn the cameras on and off remotely so as to only ever have one camera turned on at a time.
  • Page 3: Controls And Connections

    ONTROLS AND ONNECTIONS ECEIVER Video Out Jack 2.4 GHz Channel Switch ON-OFF Switch 4 4 4 4 4 AMERA 2.4 GHz Video Antenna Point the raised dimple on the antenna towards the Receiver’s location. Power Supply Jack Remove clear cap and turn lens counterclockwise to focus (replace cap for outdoor use).
  • Page 4: Connecting Up

    7. Set the Housecode dial to a letter between A and P that matches the Housecode dial on the X10 remote controls you want to use it with. Set the Unit Code dial to a number between 1 and 4*. This lets you turn...
  • Page 5: Eceiver

    Channel switch on the bottom of the Video Receiver (3 or 4). Check that the camera's remote controlled power supply is turned on (using any X10 remote control, sold separately). Note, when you first plug the power supply in, it will normally be ON.
  • Page 6: Warranty

    If you are experiencing interference between X10 Cameras and some other equipment that uses 2.4 GHz, check the other device's owner's manual for the frequencies of each channel that it uses. X10 cameras use the following frequencies: Channel A: 2.411 GHz, Chan B: 2.434 GHz, Chan C: 2.453 GHz, Chan D: 2.473 GHz.
  • Page 7 X10.com, a division of X10 Wireless Technology, Inc. (Returns Depot), 3824 North 5th St., Suite C, North Las Vegas, NV 89032 www.x10.com VK70A-09/01...

This manual is also suitable for:

Xc19aXm13aVr36a