Advanced Options; Using The Remote To Control Your Tv/Audio/Cable System; Code Search; Code Identification - X10 MK10A Owner's Manual

A
DVANCED
U
SING THE REMOTE TO CONTROL YOUR
A S
UDIO YSTEM
The remote can be set up to control the volume, channel etc., on your TV,
Cable Box, or audio system as follows.
1. Turn on the device you want to control (TV, Cable Box, or Audio
system).
2. Press and release mode button for the device you want to control (TV,
Cable, or Audio).
3. Press and hold SETUP until the green LED indicator under the button
you pressed in step 2 lights steadily. Release SETUP.
4. Enter the 3 digit Code from the Library Code Table (on page 27). The
LED turns off after the last digit entered.
5. Point the remote at the device and press the POWER button a few
times. Your device should turn off and on.
3.
2.
4.
If you can't control all the features of your TV, Cable Box, or Audio System
from the Lola Remote try another code for your brand from the code list.
Note however that it's possible that not all the features of your TV, Cable
Box, or Audio System are supported by the Lola Remote.
24
O
PTIONS
TV, C B ,
ABLE OX OR
5.
A
DVANCED
C S
ODE EARCH
If you can't find the code for your device in the Code List, you can search
for it:
1. Turn on the device you want to control (TV, Cable, or Audio system).
2. Press and release mode button for the device you want to control (TV,
Cable, or Audio).
3. Press and hold SETUP until the green LED indicator under the button
you pressed in step 2 lights steadily. Release SETUP.
4. Press the CH+ (or Power) button on the remote repeatedly until your
TV changes channel (or your Audio device turns off). If you overshoot
you can press CH -.
5. When you device responds, press Mute to install the code.
C I
ODE DENTIFICATION
To identify what code is stored in the remote:
1. Press and release mode button for the device you want to control (TV,
Cable, or Audio).
2. Press and hold SETUP until the green LED indicator under the button
you pressed in step 2 lights steadily. Release SETUP.
3. Press SETUP again.
4. Press each digit number in turn. When the indicator blinks off, the button
you pressed when it blinked is the first digit of the code set in the
remote.
5. Repeat step 4 twice to find the second and third digits.
25
O
PTIONS