Page 2
AFETY ONSIDERATIONS Remember to exercise good common sense when using your ActiveHome home automation system - especially when scheduling unattended devices. There can be some unexpected consequences if not used with care. For example, an empty coffee pot can be remotely turned on.
ETTING TARTED Because we know that you are eager to get started, we’ve kept this introduction as short as possible, but it contains very valuable information, so you should read through it very carefully. ONTROLLERS AND The first thing you need to understand is that there are two different devices you need to control your house;...
NSTALLING THE OMPONENTS RANSCEIVER ODULE The Transceiver Module receives radio frequency (RF) commands from remotes to operate a lamp or appliance plugged into it. The Transceiver Module also passes on commands over your house wiring to control other X-10 modules. Note that unlike the Lamp Module you cannot dim and brighten a lamp connected to the Transceiver Module.
ETTING YOUR UPER UTTON ESCRIPTIONS INDICATOR LIGHT The indicator light flashes when the remote is operating. POWER Works in the same way as your original remote. Also turns All Lights On, when in X-10 mode. SET UP Used for programming the remote. X-10 Lets you control X-10 modules to operate lamps and appliances around the home.
Page 7
4. Enter the 3 digit Code from the Library Code Tables. The LED turns off after the last digit entered. 5. Point the remote at the device and press the POWER button. Your device should turn off. 6. Turn your device on and press CHANNEL+.
SING TO CONTROL A TV, VCR, C ECOND ATELLITE ECEIVER The AUX button is normally used to control an audio component, but it can also be configured to control a second TV, VCR, cable box or satellite receiver. 1. Turn on the equipment you wish to control.
*Note: You may have to press CHANNEL+ many times (50+). If the device does not have a Channel Up function, use the PLAY button (VCR only) or the POWER button. DENTIFYING ODES FOUND USING EARCH ROCEDURE 1. Press and hold the SETUP until the LED indicator lights steadily.
ONTROLLING X-10 M ODULES If you have already installed the Transceiver Module, you can control it and other X-10 modules as follows: 1. Press and release the X-10 button. 2. Use the number buttons to enter the Unit Code number of the chosen module.
ActiveHome Replace your existing wall switches dimmer. On/Off and Bright/Dim functions. Other models available for 3-way and fluorescent lighting. XPANDING YOUR YSTEM HTTP://WWW.X10.COM The Dual Floodlight when it detects other modules, or macros. The Thermostat Setback Controller TH2807 mounts below...
Use a controller to trigger the Remote Chime Module SC546 to call Dad up for dinner, or warn people you’re about to turn on the sprinklers. Fit a Wireless Wall Switch RW724 anywhere you need an extra switch - with no wires. Sends commands to the Transceiver Module just like a remote.
OTHER RIGHTS WHICH VARY FROM STATE TO STATE. X-10 (USA) Inc. 91 Ruckman Rd. Closter, NJ 07624-0420 Tel:1-800-442-5138 W eb Site: http://www eb Site: http://www eb Site: http://www.x10.com eb Site: http://www .x10.com .x10.com .x10.com eb Site: http://www .x10.com Printed in China...