Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for HiBoost Mini Series
Summary of Contents for HiBoost Mini Series
- Page 1 Installation Guide Mini Series Dot 2.0...
-
Page 2: Package Contents
Dot 2.0 Package Contents Outdoor Cable Signal Booster Outdoor Antenna Indoor Whip Antenna 49.2ft NM-SMAM Power Supply waterproof tape Accessories for main parts are all provided to protect connections Booster Light Patterns Alarm(ISO) Bluetooth Wi-Fi LED STATUSINDICATORS solid blue normal slow flashing blue slight loopback ALARM(ISO) -
Page 3: Getting Started
Bands contained in the Gauges on Signal Supervisor Gauge Band Uplink Downlink 12/17 698-716MHz 728-746MHz LTE700 776-787MHz 746-757MHz 824-849MHz 869-894MHz CELL800 Please focus on the gauge that contains the band you are using Getting Started Step 1 Connect the Power Supply to the Booster Power Supply Signal Booster Connect the Booster with the App... - Page 4 Find the cell tower & Determine the outdoor antenna’s position Step 3 3.1 Find the band you are using For Android Download NetWork Cell Info Lite in the Google store and open it. It can be seen from the example picture that the frequency band is band 13. (According to the form before, you need to pay attention to Gauge LTE700) Then click MAP.
- Page 5 For ios AT & T AT & T (1) Dial *3001#12345#* (2) Follow the instructions, take the screenshots as required. 3.2 Find the cell tower (1) Enter cellmapper.net (2) Choose your own carrier and band here.
- Page 6 (3) Then enter the coordinate of where you are trying to install the signal booster, and press Enter key. (In fact when you open Cellmapper, the map on the right will automatically locate your area if you've given the site permission to access your location. If you found tower sites not even displayed on the map, it might because the app intercepts the locations for security reasons.) (4) After the map jumps to the location, you can scroll the mouse pulley and zoom it out,...
- Page 7 3.3 Determine the outdoor antenna’ s position The outdoor antenna is usually placed at one of the 4 ends of the roof. Please choose the position according to the tower’ s location. Make sure there are no barriers between the antenna and the tower. Connect the outdoor antenna with the booster Step 4 Outdoor Antenna...
- Page 8 Adjust and fix the Outdoor Antenna Step 5 Have your outdoor antenna pointed to the cell tower you found before and observe the reading on the app. Adjust the outdoor antenna accordingly. Notes: (1) The output power should be the higher the better. (2) The full output power for Dot is 10dBm.
- Page 9 Signal quality test Step 8 You could do the following: (1)First make sure the signal gauge value is unchanged from that during the outdoor antenna installation. (2)Do speed tests with the booster on and off, and make a comparison. (3)Check if the number of signal bars increases. (4)Make a phone call or send messages and check if the voice and streaming are better.
-
Page 10: Technical Specifications
Normal but No Boosted Signal DL GAIN OUTPUT POWER LED LIGHT PATTERN REASON SOLUTION Check the band you are using again. If it stays at band66,get LTE700 >=60dB >=-5dBm into the 'detail'/'setting' of 1、The band is not gagues on Signal Supervisor ISO（Alarm）... - Page 11 For more information Download Signal Supervisor or enter our website. www.hiboost.com. a. You can download the specific user manual. b. You can reach our technical support for help.
- Page 12 3150 Premier Drive,Suite 130, Irving, TX 75063 (972) 870-5666 service@hiboost.com www.hiboost.com...
Need help?
Do you have a question about the Mini Series and is the answer not in the manual?
Questions and answers