Troubleshooting; Operation; Failure Lights - Whirlpool LRF4001RY Use And Care Manual

6. Secure latches on both sides of Fabric Freshener.
NOTE: It may be necessary to push down on the top of
Fabric Freshener to secure latches.
7. Depress the pole extension button. Lower extended portion
of pole into bottom portion of pole.
Try the solutions suggested here first to avoid the cost of an unnecessary service call.

Operation

Fabric Freshener will not operate
The power supply cord is unplugged. Plug into outlet. See
"Electrical Requirements."
A household fuse has blown, or a circuit breaker has
tripped. Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician. See "Electrical
Requirements."
Fabric Freshener blows fuses or trips circuit breakers
Too many appliances are being used on the same circuit.
Unplug or relocate appliances that share the same circuit.
Time-delay fuse or circuit breaker of the wrong capacity
is being used. Replace with a time-delay fuse or circuit
breaker of the correct capacity. See "Electrical
Requirements."
Fabric Freshener does not freshen fabrics adequately
Increase amount of distilled water used in cycle cup.
Mist fabrics with distilled water.
Use Cotton Performance Pack tensioning weights for
cottons. See "Accessories" for information on ordering
additional accessories.
NOTE: Do not use weights on garments that may stretch
easily.
Fabric Freshener stops
Fabric Freshener is jumping out of cycle. Call for service.
See "Assistance."
12
8. Rotate pole assembly back into its original horizontal
position.
9. Push pole assembly into Fabric Freshener completely.
NOTE: Fabric freshener should be closed and latched before
moving Fabric Freshener to new location.

TROUBLESHOOTING

Start/Steaming and Gentle Drying indicator lights are
flashing
Infrared sensors may be dirty, or garment(s) may have
fallen onto exhaust grille. Clean the infrared sensors with a
damp or dry cloth. See "Cleaning the Fabric Freshener."
Remove any garment(s) from exhaust grille.
Gentle Drying and Cooling indicator lights are flashing
Heater thermostat is hot. Be sure bag is closed completely,
and that there are no rips or tears in the bag. If problem
persists, call for service. See "Assistance."
Start/Steaming and Cooling indicator lights are flashing
Thermostat is not working correctly. Call for service. See
"Assistance."
Start/Steaming indicator light is flashing
Boiler is not working correctly. Call for service. See
"Assistance."
All 4 indicator lights are flashing
Fabric Freshener has overheated. Allow Fabric Freshener
time to cool down. If problem persists, call for service. See
"Assistance."

Failure Lights