Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
Measuring tape
Level
Location Requirements
The worksurface can be installed on top of a front-loading washer
and dryer pair situated next to each other. The washer and dryer
must be level side to side and front to back and at the same
height. Proper installation is your responsibility.
Installation Spacing
The worksurface will fit on top of a washer and dryer that are
each 27" (68.6 cm) wide and have a spacing of approximately
1" (2.5 cm) between them for the alignment pads.
2
INSTALLATION REQUIREMENTS
1"
(2.5 cm)
Worksurface Dimensions
3"
(7.6 cm)
25"
(63.5 cm)
NOTE: The worksurface will add 3" (7.6 cm) to the overall height
of your washer and dryer.
Front edge
27
"
(69.5 cm)
Bottom view
A. Alignment pads
B. Side pads
½
56
"
(143.5 cm)
Top view
27
"
(69.5 cm)
1"
(2.5 cm)
1"
(2.5 cm)
Back edge
A
B