Using Laundry Product Dispensers; Starting Your Washer - Whirlpool Cabrio,- WTW5600X Use And Care Manual

Using Laundry Product Dispensers

3.
Add HE detergent to dispenser
Detergent tray
Add a measured amount of
HE detergent into detergent tray. This
tray holds 3 oz. (89 mL). Do not overfill tray - adding too much
detergent may cause detergent to be dispensed into the washer
too early.
IMPORTANT: Use only High Efficiency detergents. The package
will be marked "HE" or "High Efficiency." Low-water washing
creates excessive sudsing with a regular non-HE detergent.
Using regular detergent will likely result in longer cycle times and
reduced rinsing performance. It may also result in component
failures and noticeable mold or mildew. HE detergents are made
to produce the right amount of suds for the best performance.
Follow the manufacturer's instructions to determine the amount
of detergent to use.
Using Oxi or color-safe bleach:
If using an Oxi or color-safe bleach laundry boost product, add
to the bottom of the washer basket before adding clothes.
HELPFUL TIP: See "Washer Maintenance" for information
on recommended method of cleaning washer dispenser trays.
4.
Add liquid chlorine bleach
to dispenser
Liquid
Chlorine Bleach
Do not overfill, dilute, or use more than 1 cup (250 mL).
Do not use color-safe bleach or Oxi products in the same
cycle with liquid chlorine bleach.
8
5.
Add fabric softener to dispenser
Fabric softener tray
Pour a measured amount of liquid
fabric softener into tray, always
follow manufacturer's directions for correct amount of
fabric softener based on your load size. Close dispenser
drawer, then select Fabric Softener option.
IMPORTANT: Fabric Softener option must be selected
to ensure proper distribution at correct time in cycle.
Do not overfill or dilute. Overfilling dispenser will cause
fabric softener to immediately dispense into washer.
If Extra Rinse option is selected, fabric softener will be
dispensed into the last rinse.
It is normal for a small amount of water to remain in the
dispenser at the end of a cycle.

Starting Your Washer

6.
Press POWER to turn on washer
Make sure the dispenser drawer is closed completely, then press
POWER to turn on the washer.