Table of Contents
Advertisement
Focus on R&D Stable and reliable
4 Basic operation
4.1 Connect to power supply
◆ Power port, connected to city electricity AC 110/220V. Good grounding is necessary, or this may
cause permanent damage to the device.
4.2 Power on/off
◆ After connecting to the power supply, press the power switch, the power icon lights on, and the
device is turned on. Press the power switch again, the power icon is off, and the device is off.
4.3 Audio input
◆ 2W, 4W, AUX audio interface is analog audio interface, which can be connected to 2W audio
equipment (PartyLine), 4W audio equipment (CCU, RTS and other point to point audio equipment),
conventional audio equipment (such as mixer, recorder, etc.). For connection, please contact Naya
or its dealers to customize the special cable.
◆ Network interface used to connect to IPL networking. To connect the analog audio to the IPL
networking in groups, you need to use the network cable to connect the device to the existing IPL
network.
4.4 Channel setting
Use the [Channel Selection] key to select the current channel (the selected channel is highlighted).
◆
When the current channel is selected, you can do as follows:
◆
Gain adjustment: Use [IN +] [IN-] key to adjust the input gain of the current channel.
◆
Use [OUT +] [OUT-] key to adjust the output gain of the current channel.
◆
Group setting: Use the [G +] [G-] key to set the group of current channel. The audio of the current
◆
channel sent to the IPL network according to group No.
Mute setting: use the [
◆
channel will be blocked, but the audio output will remain normal.
4.5 Key lock
Short press [
] , the corresponding key light is always on, which means that all touch keys have
◆
been locked and other keys will not work.
Long press [
] until the key light is off, the key lock state is lifted, and other keys can work
◆
normally.
] key to mute the current channel. In mute mode, the audio input of the
6
Advertisement
Table of Contents
