Replace Oven Racks And Storage Or Warming Drawer - Whirlpool SF367LXS Installation Instructions Manual

NOTE: Reinstall one of the screws through the range cooktop
to hold the orifice spud holder in place while removing and
replacing the orifice spuds.
A
B
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
3. Apply masking tape to the end of a
the gas orifice spud in the nut driver while changing it. Press
nut driver down onto the gas orifice spud and remove by
turning it counterclockwise and lifting out. Set gas orifice spud
aside.
A
B
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
4. Remove the cardboard orifice spud holder located on the
back of the range near the gas inlet. Gas orifice spuds are
stamped with a number, marked with 1 color dot, and have a
groove in the hex area. Replace the Natural gas orifice spud
with the correct LP gas orifice spud.
A. Groove
Refer to the following chart for correct LP gas orifice spud
placement.
LP Gas Orifice Spud Chart for Standard Surface Burners
Burner Rating Color
12,000 BTU Green/Magenta
11,000 BTU Green/Yellow
8,000 BTU Green/Lt. Blue
5,000 BTU Green/Brown
NOTE: Refer to the Model Number and Serial Number Plate
located behind the left side of the storage or warming drawer for
proper sizing of spuds for each burner location.
C
D
" nut driver to help hold
C
D
A
Size ID Number
1.03 mm L103
0.99 mm L99
0.80 mm L80
0.65 mm L65
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner
1. Remove oven racks.
2. Use a ½" combination wrench to turn the orifice hood down
snug onto pin (about 2 to 2½ turns).
IMPORTANT: Do not overtighten.
The oven bake burner flame cannot be properly adjusted if
this conversion is not made. See "Adjust Oven Bake Burner
Flame" section.
A
A. Orifice hood
B. Pin
C. Natural gas: increase gas - increase flame size
(preset at factory for Natural gas)
D. LP gas: decrease gas - decrease flame size
To Convert Oven Broil Burner
Use a ½" combination wrench to turn the orifice hood down snug
onto the pin (about 2 to 2½ turns).
IMPORTANT: Do not overtighten.
The oven broil burner flame cannot be properly adjusted if this
conversion is not made. See "Adjust Oven Broil Burner Flame"
section.
A
A. Lock screw
B. Orifice hood
Replace Oven Racks and
Storage or Warming Drawer
Replace oven racks in oven cavity. Insert storage drawer or
warming drawer into slide rails on sides of drawer opening. Lift
front of drawer slightly and push firmly to close drawer.
A
B
D
C
B
13